Radio Systems Radio Fence Plus Remote Trainer Manuel d'instructions télécharger pdf (Page 4)

To complete installation you may need the following items:

• Wire stripping pliers

• Wire nuts or wire fasteners, electrical tape and waterproofing compound (splicing boundary wire)

• Straight edged spade or a lawn-edger (for cutting groove in yard)

• Grounding rod and clamp (for grounding containment transmitter)

NOTE: PetSafe has a team of trained professionals all over the country ready to install your fence for you. Please

call our Customer Support at 800-732-2677 for more information on professional installation or for answers to any

other questions you may have.

THE CONTAINMENT SYSTEM

Laying out the System

Basic Planning Tips:

• The boundary wire must make a continuous loop back

to the transmitter.

• Make a layout that is suitable for your yard. Sample

layouts are provided.

• Always round the corners of your boundary with the wire.

Sharp corners will distort the signal.

• The transmitter will transmit an adjustable signal from

approximately two to thirty feet on either side of the boundary

wire. Be sure to leave enough area so that your dog can move

about freely within the safe area boundaries.

Locate the Transmitter

• Place the transmitter INDOORS ONLY and near an electrical outlet. The transmitter is not waterproof.

• Install the transmitter at least three feet from any large metal objects such as breaker boxes, water

heaters, metal garage doors, or washer and/or dryer.

• Secure the transmitter to a stationary surface using the appropriate mounting hardware. A mounting

template is located on the back cover of this manual.

• When installing the transmitter make sure the wire twists are not cut off or pinched by a window,

door or garage door.

• Install the transmitter only in buildings that meet state and local electrical codes, to prevent fires

and electrical hazards.

• If it is necessary to drill a hole make sure there are no electrical wires, nails or screws inside the

area you are drilling.

Layout the Boundary Wire

• Lay the wire along your proposed boundary. Connect it to the transmitter.

• Running wire parallel to electrical wires, telephone wires, television cables or antenna, or near

satellite dishes will result in signal interference. If you must cross, do so at 90 degree angles.

FRONT OR BACK ACCESS

BASIC LOOP WITH GARDEN

Sample Layouts:

Twisted Wire

Transmitter

1 2 3 4 5 6 7 8 9 ... 23 24

Pas de commentaire

Radio Systems Radio Fence Plus Remote Trainer Manuel d'instructions Page 4