Radio Systems Radio Fence Plus Remote Trainer Manuel d'utilisateur télécharger pdf (Page 10)

10 Customer Care Center 1-800-732-2677

Pairing the Receiver Collar for One

Dog Operation

To pair the Receiver Collar to work with a new Handheld Transmitter or to pair a new

Receiver Collar to work with your existing Handheld Transmitter:

1. Turn the Receiver Collar off.

2. Press and release the Transmitter’s Dog Select Button and ensure the Red LED

ﬂashes one time to indicate Dog 1 is set.

3. Press and hold the On/Off Button on the Receiver Collar continuously for 5 seconds,

then release the button. The Green LED ﬂashes once every second after the button is

released and waits to receive an ID for up to 10 seconds.

4. Press and release any blue correction button once during the 10 second

programming mode. (This sends the Transmitter’s unique ID to the Receiver.)

5. When the Green LED light on the Receiver ﬂashes 5 times, the new ID has been

received. This can be veriﬁed by pressing any button on the Transmitter.

6. If the Receiver does not receive the new ID, it will automatically exit the pairing mode

and retain its previous ID.

Pairing the Receiver Collar for Two

Dog Operation

For a 2 Dog System, additional Receiver Collars are available at www.petsafe.net or

through our Customer Care Center.

Adding Dog 2

Remote Transmitter

1. Set the Level Select Switch to 2.

2. Press and hold the Transmitter’s Dog Select Button continuously for 5 seconds, then

release the button. (The Green LED will blink 3 times.)

3. Press and release the Transmitter’s Dog Select Button again and ensure the Green

LED ﬂashes one time to indicate Dog 2 is set.

Receiver Collar

1. With the Receiver in the off position, press and hold the On/Off Button continuously

for 5 seconds, then release the button. The Green LED will ﬂash once per second even

after the button is released for up to 10 seconds.

2. During this 10 second programming mode, press and release any blue correction

button on the Transmitter once. (This sends the Transmitter’s unique ID to the Receiver.)

3. The Green LED light on the Receiver Collar will ﬂash 5 times. The new ID is now set.

To verify press any of the blue correction buttons.

Multi-Dog Functions

1. To select between Dog 1 and Dog 2, press and release the Dog Select Button to

toggle back and forth between Dog 1 (Red LED) and Dog 2 (Green LED).

2. The Transmitter will remember the last dog selected.

Step

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Radio Systems Radio Fence Plus Remote Trainer Manuel d'utilisateur Page 10