Radio Systems Radio Fence Plus Remote Trainer Manuel d'utilisateur télécharger pdf (Page 8)

8 Customer Care Center 1-800-732-2677

Prepare the Receiver Collar

Charge the Receiver Collar

1. Lift the rubber dust cover protecting the Receiver

Collar Charging Jack.

2. Connect one of the charger connectors to the

Receiver Collar Charging Jack (2A).

3. Plug the charger into a standard wall outlet. The

Red LED will light up. When fully charged, the LED

will change to Green.

4. When charging is complete, be sure to replace the

rubber dust cover.

To Turn the Receiver Collar On

1. Press and hold the On/Off Button (2B) until

the Green LED light comes on. (This takes

approximately one second.)

2. Release the On/Off Button.

In normal mode, the Green LED will ﬂash once every 5

seconds, indicating the Receiver Collar is on and ready

to receive a radio signal from the Handheld Transmitter.

To Turn the Receiver Collar Off

1. When you press the On/Off Button, the Red LED

light will come on. Hold down the button until the

Red LED turns off (approximately 5 seconds).

On/Off Button

2. Release the On/Off Button.

To extend the life between charging cycles, turn the Receiver Collar off when it is not in use.

Approximate battery life between charges is 15-20 hours, depending on frequency of use.

Receiver Indicators

Condition Red LED

Normal Operation - Low Battery

3 ﬂashes every 5 seconds

Correction ON while delivering correction

Charging ON

Condition Green LED

Pairing Mode Flashes once every second

Normal Operation - Good Battery Flashes once every 5 seconds

Charging Complete ON

Step

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Radio Systems Radio Fence Plus Remote Trainer Manuel d'utilisateur Page 8