Radio Systems Radio Fence Plus Remote Trainer Manuel d'utilisateur télécharger pdf (Page 10)

10 1-800-732-2677

Set the Boundary Width

and Test the Receiver Collar

The Boundary Control Switch on the side of the

Fence Transmitter has three settings (6A). Setting B

is used for most properties. The following table will

indicate the setting you should use.

Amount of Wire Setting

Up to 1300 feet

1300-2400

Greater than 2400 feet

Use the Boundary Width Control knob to set the

width of the Warning Zone and Static Correction

Zone (6B). Set the Boundary Width as wide as

possible to give your pet the widest Warning and

Static Correction Zones without reducing the

Pet Area too much.

Note: The Boundary Width Control knob does not

change the Static Correction Level.

To identify the Warning and Static Correction

Zones, make sure the Receiver Collar battery

is properly installed and the Test Light

Contacts are touching the Contact Points

(6C, 6D). Walk toward the Boundary Wire

with Contact Points pointing up and holding

the Receiver Collar at your pet’s neck level

(6E) until the Receiver Collar beeps (6F).

Test Light Contacts

6C 6D

Note: The Receiver Collar is

waterproof, which can make

the beep hard to hear.

If the Receiver Collar does

not beep at the desired

range, adjust the Boundary

Width Control knob to the

desired setting. Turning the

BoundaryWidth Control

knob clockwise increases

the Boundary Width while

turning it counterclockwise

decreases it (6B). Repeat

Boundary

Wire

Boundary

Wire

this activity as needed until the Receiver Collar beeps at the desired distance from the Boundary Wire.

The numbers on the Boundary Width Control knob indicate signal strength and are not representative of Boundary

Width footage. If adjusting the Boundary Width Control knob does not give the desired range, adjust the Boundary

Control Switch to another setting to achieve your desired range. If using a Double Loop, you may need to increase

the separation of the Boundary Wire to achieve desired range.

The Receiver Collar beeps as a warning tone and ticks when delivering a Static Correction. After hearing the beep,

continue to walk towards the wire. The Receiver Collar should tick and the Test Light should ﬂ ash, indicating the

Static Correction as you enter the Static Correction Zone (6G). A warning tone and the ﬂ ashing of the Test Light

indicate that the Receiver Collar and the system are working properly and that you are ready to start burying the

Boundary Wire. If the Receiver Collar did not beep or the Test Light did not ﬂ ash, see the “Troubleshooting” section.

Save Test Light for future testing.

Note: The Boundary Width is broken down into 20% Warning Zone and 80% Static Correction Zone.

Step

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Radio Systems Radio Fence Plus Remote Trainer Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Soins des animaux Radio Systems Radio Fence Plus Remote Trainer