Radio Systems Radio Fence Plus Remote Trainer Manuel d'utilisateur télécharger pdf (Page 23)

www.petsafe.net 23

Option 2: Follow the procedure below:

1. Unplug the Fence Transmitter.

2. Connect both ends of your twisted Boundary Wire to one Boundary Wire

Terminal.

3. Measure and cut a Test Wire which is half the length of your total Boundary

Wire footage.

4. Connect one end of Test Wire to the other Boundary Wire Terminal.

5. Locate the halfway point of your boundary and cut the Boundary Wire.

6. Splice the other end of the Test Wire to either side of your Boundary Wire where

you cut it in half.

7. Plug in the Fence Transmitter and check the Loop Indicator Light. If the Loop

Indicator Light is on, you can assume the break is in the other half of the

Boundary Wire.

8. If the Loop Indicator Light did not come on, you may assume there is a break in

Te s t

Wire

this portion of the Boundary Wire. However, there is a small chance of having more than one break in your

system. Be sure to check both halves of your entire loop.

9. Replace the damaged Boundary Wire with new Boundary Wire.

10. Reconnect the Boundary Wire to the Fence Transmitter.

11. Check the Loop Indicator Light. If the Loop Indicator Light is on, test the system with the Receiver Collar.

___________________________________________________________________________________________________________

Remote Trainer Testing

1. Hold the Test Light Contacts to the Contact Points

2. Press a Stimulation Button on the Remote Transmitter

3. The Test Light will ﬂ ash.

Note: At higher Intensity Levels the Test Light will ﬂ ash brighter.

Save the Test Light for future testing.

If the Test Light does not ﬂ ash, refer to the Troubleshooting section, or call the

Customer Care Center.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Radio Systems Radio Fence Plus Remote Trainer Manuel d'utilisateur Page 23