Radio Systems Radio Fence Plus Remote Trainer Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8 1-800-732-2677
Position the Boundary Wire
Lay out the Boundary Wire using your proposed boundary and test the system BEFORE burying the wire or
attaching it to an existing fence. This will make any layout changes easier.
Running the Boundary Wire parallel to and within fi ve feet of electrical wires, neighboring containment systems,
telephone wires, television or antenna cables, or satellite dishes will cause an inconsistent signal. If you must cross
any of these, do so at 90-degree angles (perpendicularly).
If separating the wire by at least fi ve feet from a neighboring containment system’s wire does not reduce the
inconsistent signal, contact the Customer Care Center at 1-800-732-2677.
To Twist the Boundary Wire (3A)
Twisting the Boundary Wire cancels the signal and allows your pet to cross over that area safely. Plastic or metal
piping will not cancel the signal.Twist the Boundary Wire 8 to 10 times per foot to cancel the signal.
To Splice or Repair the Boundary Wire (3B)
If you need additional Boundary Wire to expand your wire loop, you will need to splice the wires together. Note the
locations of all splices for future reference. Most Boundary Wire breaks occur at splices.
Strip approximately one-half inch of insulation off the ends of the Boundary Wires to be spliced. Make sure the
copper Boundary Wire is not corroded. If the Boundary Wire is corroded, cut it back to expose clean copper wire.
Insert the stripped ends into the wire nut and twist the wire nut around the wires. Pull on the wires to make sure
you have a strong splice connection. Apply waterproofi ng compound (e.g. silicone caulk) in and around the wire nut
or wrap the wires and the wire nuts with electrical tape to prevent moisture from corroding the copper.
If your splice pulls loose, the entire system will fail. Make sure your splice is secure.
10 Twists/ft.
1
1/2"
1/2"
2
Step
3
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire